Sealer Remover

Brush away leaves and debris.

Shake well before use.

Determine Working Times - To establish correct removal timings, suitability and compatibility, always test an inconspicuous area before use by creating 6 small test samples of no more than 50mm round with the liquid generously applied. Apply the 6 samples at the same time - spaced sufficiently apart to allow individual washing and removal. Remove 1 sample at a time, at 30 minute intervals. This will give you the correct timing for the product; whichever sample is perfectly clean after washing. This is the timing you will need for the whole area.

Apply a thick, even coat at a rate of 1-1.5m2 per litre. Do not allow the product to dry out.

After the length of time determined by your test patch, remove the surface coating with a power washer or a stiff brush and running water.